Whirlpool Duet Washer Not Spinning Fast

If the lid switch does not have continuity replace it.

Whirlpool duet washer not spinning fast.

Previous topic next topic. And if the door lock is open power will not flow to the motor. Of course this is based on the assumption that you have the most popular design of their washer. Whirlpool washers are not usually supposed to spin and drain at the same time.

Remove the front panel of the washer and locate the clear tube going from the tub to the water level switch. Model wfw8500sr0 whirlpool duet sport ht spins out sometimes but does not spin out other times. It s supposed to drain all the excess water out and then start spinning. The lid switch assembly prevents the washer from spinning when the lid is open.

The lid switch prevents the washer from spinning if the lid is open. Whirlpool duet washer washer not spinning fast enough. Clean the debris from the hose by blowing on the hose or tapping it on the side. If you find your whirlpool duet washer not spinning fast enough a diy inspection can reveal the cause.

Get shopping advice from experts friends and the community. If the lid switch assembly fails the washer will not spin. Use this page to troubleshoot the issue. Here are some easy fixes you can try at home to pinpoint the problem.

The regular soap suds up and the pressure switch is getting faulty reading thinking that to much water is in the unit if water is in the unit it will not spin if the motor turns you do not have a motor issue the control tells the motor when to turn and how fast to turn you can try to run a cycle with 1 cup of white vintager with no clothes this should break down the excess soap and flush it out if you do this and it still will not spin you have a bad control. The pump is pumping out the water but the spin cycle never starts at times. If the tub is full of water when it s trying to spin it will spin very slowly. If lint or debris has gotten into the water level hose then the washer may not spin fast.

Over the last week i ve noticed my. Amym269 1 posted. To determine if the lid switch assembly is defective use a multimeter to test the lid switch for continuity. Door lock switch stays in series with wash motor electrical circuit.

At times we have to run the drain spin cycle 2 3 times before it will finally spin out at high speed. Saturday september 3 2016 4 22 47 pm utc rank. 5 10 years.