Something stuck on the drainpipe or filter drain.
Whirlpool duet washer door locked flashing light.
Check the lid switch and striker.
First try to just unplug the washer for 60 seconds or flip the circuit breaker off to the washer and usually the control panel will reset and the door lock light will stop flashing.
Whirlpool top loader with locked door.
Problem is the lid switch.
Issue in drain pump.
Whether your clothes are in the washer or still in the clothes basket a whirlpool duet washer with a door that won t unlock is likely to be a huge problem.
If you have a whirlpool top loader and the door is locked with a flashing light here are some things you ll need to check.
The dance pause button light comes on.
Its mean door is not unlocked and need to replace the drain pipe.
Then the changing the cycle doesn t work.
The f dl code indicates a door lock error on the machine.
When the door fails to lock to allow the cycle to begin it attempts to lock itself at least six times before the error appears on the digital display screen.
Common issues that cause whirlpool washer door locked light flashing.
Confusing codes flashing on the washer control panel add to your frustration.
The door locks and stays locked.
Whirlpool washer door locked light flashing.
In this condition your dryer not done work properly.
The whirlpool duet washer has a series of error codes that indicate specific problems.
But all is not lost.
Make sure it s not out of alignment.
Door still locked the the add a garment light turns on.
Following fabric care directions is impossible if your whirlpool duet washer door won t open.
Other than that you ll need to manually unlock the door.
When the lock light is blinking it typically means that the unit either took to long to fill with water in which case it ll go into flood mode and keep draining for 15 20 minutes and unlock on it s own or there is a glitch in the electronics and just unplugging it for 60 seconds will reset the issue.
My washer was stuck in the locked position and this is how i fixed it.
I choose a cycle press start.
The striker is the part that helps press down the lid switch.