Which Side To Face Up When Cutting Laminate Flooring

Now it s cutting time.

Which side to face up when cutting laminate flooring.

That way any splintering occurs out of sight on the side that faces. Mark the cut line on top of the tape and cut with a jigsaw with a special blade. Keep your board in place using a stand or a clamp. Along with taking and making accurate measurements safety should always be at the head of any laminate flooring project.

If you mix the two up and start with the groove side you will have difficulty completing the installation because you will essentially be installing the flooring backwards in the line drawing above note the orientation for the tongue and the groove. This process can take up to 2 hours depending on how many boards you need to cut. It must always be kept in mind that you have to follow the right process of how to cut laminate flooring without chipping its coating and to be careful about vinyl flooring direction while it is being cut. Mark and measure where you want to cut the boards beforehand with chalk or pencil.

To avoid this follow these steps when cutting your new flooring. The chipped laminate flooring will be less durable and also look sloppy. Laminate boards can chip if separated incorrectly. Cutting laminate flooring step 3.

Lay your laminate flooring perpendicular to the front door or the point of entry from your front door or the main point of entry in a room lay your laminate floor to the direction of your line of sight. Hold the jigsaw vertical so the blade runs smoothly from one edge of the laminate to the other. The direction of the laminate will basically become perpendicular to that door. When installing the first row of laminate flooring i prefer to start on a wall that is as straight as possible.

Usually an outside wall will be the best place to start. Safety when cutting laminate flooring boards. If cutting the laminate face up place painter s tape on the laminate along the pattern to keep it from chipping. Place your board with the top face up only if you use a blade with downward oriented teeth and lock the straight edge with two c clamps.

Which side is the tongue which the groove and which goes first during installation the tongue is the side that you will want to place against the wall as you start your laminate flooring installation. Use a straight edge or another laminate flooring plank to guide the jigsaw or the circular saw.