Well Water Systems How They Work

How a water well works.

Well water systems how they work.

When the water pressure drops below 40 psi the pressure switch turns the pump on bringing the water pressure back up within range. The pipes known as the casing also typically contain a mechanical pump that draws the water out of the well and pushes it up to the pressure tank where it may feed into the home. Home well water systems work by connecting a series of pipes from a pressure tank within the home to an underground water source known as a well. The pumped water new water that s drawn from the well by the suction at the jet then combines with the drive water to discharge into the plumbing system at high pressure.

Other well water systems are gravity fed and use gravity to provide water pressure to the house. Turn on building water at a plumbing fixture. A pump draws water from the aquifer for distribution through the plumbing system. Your well water systems contractor will use one of three techniques the rotary auger or drive point method.

Well water treatment and filtration systems remove soluble inorganic contaminants and sediment from water while automatically back washing to clean the filter and extend its life. Water runs out of the supply faucet into the fixture down the drain water pressure and flow are being supplied to the building from a water pressure tank. First a water well contractor will dig and drill until they tap into the richest source of groundwater on your property. This might require a contractor to dig to depths as great as 500 feet.

When the water pressure is at an adequate level the pressure switch turns the pump back off. Typical well systems have a water pressure range of 40 60 psi. A well is basically a hole in the ground held open by a pipe or casing that extends to an aquifer. Some well water systems use a large storage tank to store the water before it is pumped again to the house.

Open a sink valve tub valve or flush a toilet.